wiki:pinouts
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
wiki:pinouts [2022/03/04 10:42] vizycam [Using with software] |
wiki:pinouts [2022/03/08 11:04] (current) vizycam [Notes] |
||
|---|---|---|---|
| Line 23: | Line 23: | ||
| * As inputs, B0 through B3 each have a 22K pull-up resistor to 3.3V. | * As inputs, B0 through B3 each have a 22K pull-up resistor to 3.3V. | ||
| * As outputs, B0 through B3 each vary between 0V (low) to 3.3V (high). | * As outputs, B0 through B3 each vary between 0V (low) to 3.3V (high). | ||
| - | * As "high power" outputs, B0 through B3 can each sink up to 1000mA, which applies during logic low (0V). Each channel can source up to 5mA, which applies during logic high (3.3V). | + | * As "high power" outputs, B0 through B3 can each sink up to 1000mA, which applies during logic low (0V). Exceeding 1000mA may cause damage to Vizy's power board. Each channel can source up to 5mA, which applies during logic high (3.3V). |
| - | * The maximum carrying current of the 12V signal is 4.0A. | + | * The maximum carrying current of the 12V signal is 4.0A. Exceeding 4.0A may cause damage to Vizy's power board. |
| - | * The 5V signal can source up to 2A. | + | * The 5V signal can source up to 2A. |
| * All I/O connector signals are protected from electrostatic discharge. | * All I/O connector signals are protected from electrostatic discharge. | ||
wiki/pinouts.1646412132.txt.gz · Last modified: 2022/03/04 10:42 by vizycam
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
