This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
wiki:make_treat_dispenser [2022/03/08 11:00] vizycam |
wiki:make_treat_dispenser [2022/03/08 11:01] vizycam |
||
---|---|---|---|
Line 172: | Line 172: | ||
- | Then attach the extension cord to pins 1 (ground) 2 (12V) on Vizy's terminal block. (We recommend these pins because the solenoid current may exceed Vizy's maximum I/O current of 1000mA, whereas the 12V signal can switch up to 4A. You can verify that the solenoid you're using consumes less than 1000mA with an ammeter and then you can use one of the I/O signals to switch the solenoid.) | + | Then attach the extension cord to pins 1 (ground) and 2 (12V) on Vizy's terminal block. (We recommend these pins because the solenoid's operating current may exceed Vizy's maximum I/O current of 1000mA, whereas the 12V signal can switch up to 4A. You can verify that the solenoid you're using consumes less than 1000mA with an ammeter and then you can use one of the I/O signals to switch the solenoid if you wish.) |