new_page
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
new_page [2022/09/01 21:02] matt created |
new_page [2022/10/10 11:04] matt |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | DokuWiki supports **bold**, //italic//, __underlined__ and ''monospaced'' texts. | + | ======= How to ReImage Vizy ======= |
| - | Of course you can **__//''combine''//__** all these. | + | <introduction blurb> |
| + | |||
| + | ==== Four Steps ==== | ||
| + | 1. Download latest Vizy Image from here [[https://vizycam.com/sd/vizy_image2021.img|Vizy Image]] \\ | ||
| + | 2. Retrieve microSD card \\ | ||
| + | 3. Image the sd card using software \\ | ||
| + | 4. Reinsert MicroSD to Vizy and Update via Web Interface \\ | ||
| + | *note*: Update when connected to reliable internet. Errors can occur when updating from unreliable internet, non-ethernet connections especially * | ||
| + | |||
| + | ==== Steps Expanded ==== | ||
| + | |||
| + | === Retrieve MicroSD Card === | ||
| + | - unscrew four screws at bottom of Vizy --> image : Vizy updside down, arrows to screws \\ | ||
| + | - use Vizy screwdriver, philips side --> image : image of screwdriver \\ | ||
| + | {{:vizy_upsidedown_covered2.jpg?200|}} | ||
| + | {{:vizy_screwdriver_philips.jpg?200|}} | ||
| + | {{:vizy_upsidedown_uncovered.jpg?200|}} | ||
| + | {{:vizy_upsidedown_uncovered_with_baseAndScrews.jpg?200|}} \\ | ||
| + | |||
| + | |||
| + | - carefully remove microSD card by either lifting Vizy from case or from where it is. Careful of damage by lifting. The camera cable is here. \\ | ||
| + | -- * close up --> image : camera cable connection \\ | ||
| + | -- * close up --> image : full removal \\ | ||
| + | |||
| + | === ReImage MicroSD Card === | ||
| + | - prepare microSD card : microSD to SD converter, SD to USB \\ | ||
| + | -- * close up --> image : microSD to SD converter \\ | ||
| + | -- * close up --> image : SD to USB \\ | ||
| + | - recommend offical RaspberryPi Imager \\ | ||
| + | - use pi imager to select customer image and usb for card. \\ | ||
| + | - carefully remove after writing is complete \\ | ||
| + | |||
| + | === Reinsert to Vizy === | ||
| + | - replace microSD in Vizy and carefully rebuild Vizy, don't forget the screws \\ | ||
| + | - * connect to reliable internet and update \\ | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | {{:pi_imager_config.png?200|}} \\ | ||
| + | {{:pi_imager_select_custom.png?200|}} \\ | ||
| + | {{:sdcard_components_separate.jpg?200|}} \\ | ||
| + | {{:sdcard_components_together.jpg?200|}} \\ | ||
| + | {{:vizy_screwdriver_philips.jpg?200|}} \\ | ||
| + | {{:vizy_upsidedown_apart.jpg?200|}} \\ | ||
| + | {{:vizy_upsidedown_covered.jpg?200|}} \\ | ||
| + | {{:vizy_upsidedown_covered2.jpg?200|}} \\ | ||
| + | {{:vizy_upsidedown_uncovered.jpg?200|}} \\ | ||
| + | {{:vizy_upsidedown_uncovered_with_baseAndScrews.jpg?200|}} \\ | ||
| - | You can use <sub>subscript</sub> and <sup>superscript</sup>, too. | ||
| - | You can mark something as <del>deleted</del> as well. | ||
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
